11/2/2022 0 Comments Mortise lock![]() ![]() Use the marks on the edge of the door as guides to drill a series of holes into the edge of the door to create the hole to take the body of the mortise lock. Use a sharp chisel along the marked lines to establish the edges - this should stop any surface wood from lifting beyond the lines required. Mark the centre line of the door thickness and mark out the width of the mortise lock body equally about the centre line. Transfer the positions of the top and bottom of the mortise lock body to the edge of the door. ![]() Position the mortise lock body against the side of the door and mark the top and bottom against the side of the door.Īlso mark the positions of the keyhole and handle spindle by marking through the body of the mortise lock - make an allowance for the front plate of the lock as this will be recessed into the edge of the door.ĭrill the holes for the spindle and keyhole - make the spindle hole at least as big as the spindle boss of the lock - for the keyhole, drill the top hole and cut out the shape using a thin pad saw. Start by deciding on the height of the mortise lock if in doubt, check the height of other locks in the property as ideally all the door handles should be the same height from the floor. #Mortise lock how toIt may be necessary to reverse the latch on the lock so that the curved part of the latch strikes the door frame first when the door is closed, this here for how to reverse the latch on mortise locks. Fitting a mortise lock is quite straightforward but does need accurate measurements to ensure everything fits correctly.Ī mortise lock will normally specify the thickness of door it is designed to fit, problems will only normally arise if an attempt is made to fit a lock to a too thin a door. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |